Generic CONFAST 1/4" x 1-1/2" Stainless Steel Hammer Nail in Drive Anchor (100 per Box)

Applications The anchor is made from Zamac body - 304 Stainless steel nail. This anchor is designed for use in Concrete, Block, and Brick. Environment The anchor is designed for use in a Wet environment. Hole Diameter/Bit Diameter The anchor requires a 1/4" hole to be drilled in the base material (Concrete, Block, and Brick). The hole should be drilled with carbide tipped bit that meets ANSI standards and used in a hammer drill. Diameter of Anchor The diameter of the anchor is 1/4". Length Anchor The length of the anchor is 1-1/2" Minimum Embedment The minimum anchor embedment into the concrete is 3/4". Therefore, the anchor must be installed so that a minimum of 3/4" of the anchor is embedded into the concrete. Spacing between Anchors Each anchor must be spaced a minimum distance of 2-1/2" from each other when measured center to center. Edge Distance It is very important not to install the anchor any closer than 1-1/4" from an unsupported edge of the concrete.

View full description