Specifications:
Used for: Frameless glass shower door bottom
Material: New high quality PVC raw material
Color: Transparent
Please measure your glass door thickness correctly:
1/2-inch(12mm appr. 0.472in)
3/8-inch(10mm appr. 0.394in)
5/16-inch(8mm appr. 0.315in)
1/4-inch(6mm appr. 0.236in)
Seal Strip Length: 0.7m(27.56in)
Water Retaining Edge Lengt: 25mm
Features:
Suitable for Sliding doors, especially for the bathroom door with a large gap between the bottom of the door and the ground, about 15-25mm vertical gap.
The hard stuck slot is used to catch the bottom of the glass door, and the lower two soft water retaining edges are used to block the water.
If you need, the shower door seal strip can be properly cut to the right size
The card slot is hard straight and can't be rolled(Not suitable for curved glass doors)
Installation method (No glue required):
1.Clean the bottom of the glass and do not leave any stains or water spots.
2. The hard pvc card slot is fixed to the glass door.
3. Put the short waterproof edge(8mm) inside of shower door to direct the flow of water. Long waterproof edge(25mm) placed on the outside to water retaining
4. If the water retaining edge is too long and affected the closing, you can be appropriately cut with scissors.
Note: If it is difficult to install, use warm water (not boiling water) soak for 10 minutes before installing.
Also you can also tap with your hand or a small stick. Or rub some soapy water on the glass, you must not use cooking oil or the like.
Package Included:
1 x Shower Door Bottom Seal Strip
View full description
Item# : SPM9272668829
Model # : TM